Forum: Model A (1928-31)
04-13-2016, 07:15 PM
|
Replies: 6
Views: 1,783
Re: 1928 Coupe Trunk Handle
I do not have a key and the lock has been damaged. Can I replace just the lock? Thanks for you reply/support. Saltman
|
Forum: Model A (1928-31)
04-13-2016, 06:18 PM
|
Replies: 6
Views: 1,783
1928 Coupe Trunk Handle
I have a 1928 Special Coupe that has a T-handle (w/round stop/medallion) on the trunk. I've read on this site that this is correct for this year. However, I have never seen a new replacement like...
|
Forum: Model A (1928-31)
03-03-2016, 08:54 PM
|
Replies: 3
Views: 1,190
1928 Special Coupe seat modification
Hey Model A'ers,
Is there any practical way to modify the seat on subject vehicle so it will go further back. Really don't care if its adjustable or not... however, a couple more inches would be...
|
Forum: Model A (1928-31)
06-18-2015, 02:44 PM
|
Replies: 7
Views: 1,592
Model A Roadsters
I have some general question about the roadsters:
. Did all of them just come with the rumble seat?
. If so, can they be easily converted to a trunk?
. Are the doors the same width as...
|
Forum: Model A (1928-31)
02-11-2015, 07:59 PM
|
Replies: 8
Views: 4,059
Early 1928 Model AA
Was a 1 ton model made in early 1928? If so, what is the difference between it and a 1 1/2 ton? Was it just dual wheels and heavier springs or what? I have tried to reference the 1928 AAs and just...
|
Forum: Model A (1928-31)
07-30-2014, 06:45 PM
|
Replies: 3
Views: 1,662
Shock Disassembly
I have seven original shocks that I am trying to disassemble so I determine if they are good or not... or rebuildable. Unbelieveably, I have managed to get all the valves out by heating/quenching...
|
Forum: Model A (1928-31)
07-25-2014, 04:34 PM
|
Replies: 4
Views: 1,602
Re: Shock Dumb...
Kevin, Thanks-a-lot! You were the one that responded, in length, about my shock disassembly questions. I read it many times and hard copied it for reference and certainly agree that this makes...
|
Forum: Model A (1928-31)
07-25-2014, 03:16 PM
|
Replies: 4
Views: 1,602
Shock Dumb...
Although it may sound stupid to ask these questions but I'm going to let them fly anyway... When I turn the shaft on a good shock with my crescent wrench or such, how should it perform? How much...
|
Forum: Model A (1928-31)
07-18-2014, 05:00 PM
|
Replies: 2
Views: 1,568
Shock Disassembly
I have 3 of the 4 original shocks for my 28 coupe. According to the judging standards, they are all of the 2nd ones used from Feb 28 - July 28. They are the ones with the long pointer. The 3 are in...
|
Forum: Model A (1928-31)
10-01-2013, 04:08 PM
|
Replies: 8
Views: 3,288
Rusted curved panels above door
The curved panels above the doors of my 1928 Special Coupe has pitting and a couple of rusted through holes in it... on both sides, otherwise, they are quite sturdy. The curved panels above the...
|
Forum: Model A (1928-31)
09-22-2013, 05:09 PM
|
Replies: 5
Views: 1,820
Re: Door Latch Removal
For those that have some interest in my problem getting my 28 coupe driver side door latch off... I was right in, the problem is with the square handle-hole housing hitting the metal window felt...
|
Forum: Model A (1928-31)
09-22-2013, 04:27 PM
|
Replies: 5
Views: 1,820
Re: Door Latch Removal
If anyone is still watching.... Only after more tries to get my driverside door latch out of the door hole, do I see the problem. When I try and tilt the interior side of the latch out, it can not...
|
Forum: Model A (1928-31)
09-22-2013, 02:07 PM
|
Replies: 5
Views: 1,820
Re: Door Latch Removal
Tom... I have read your posts and others regarding the door latch removal problem. Sounds like pretty much the same problem as you have on your 29 tudor... except, on mne, I can't get the interior...
|
Forum: Model A (1928-31)
09-22-2013, 01:11 PM
|
Replies: 5
Views: 1,820
Door Latch Removal
Been trying for a couple of hours to remove the driver's side door latch on my 28 coupe... I have removed all screws, etc. I just can't get the latch to come out of the door. The inside latch ear...
|
Forum: Model A (1928-31)
07-22-2013, 06:06 PM
|
Replies: 4
Views: 2,202
Re: NEW side window felt channel kit install...
Thanks Christian & Jmeckel...
I test fitted one side piece and they are rather tight in both width and length. Also, the structure of the side pieces are rather 'gooey' which might help prevent...
|
Forum: Model A (1928-31)
07-22-2013, 05:31 PM
|
Replies: 4
Views: 2,202
|
Forum: Model A (1928-31)
07-21-2013, 05:47 PM
|
Replies: 6
Views: 1,645
Front bumper arm installation
Just tried to mount a new set of front bumper arms for my 28 Coupe. After installation, I discovered that the right arm is not only about 2 1/2" bent too far out but, the front holes are too small...
|
Forum: Model A (1928-31)
07-21-2013, 03:28 PM
|
Replies: 9
Views: 2,160
Re: DUMBFOUNDED... still need help!
Hey Tinbasher...
You have made my day... after 3 days of headscratching and beginning to loose faith in my very own sensibilites, do I now see what panel you are talking about. After reading your...
|
Forum: Model A (1928-31)
07-21-2013, 03:00 PM
|
Replies: 9
Views: 2,160
|
Forum: Model A (1928-31)
07-21-2013, 02:58 PM
|
Replies: 30
Views: 7,232
Re: The "new" Mac's: faster!
Although I generally use Snyder's due to their friendly/almost like family disposition as well as quick shipping, I recently ordered a couple of parts from MACs that Snyder's did not have I have...
|
Forum: Model A (1928-31)
07-21-2013, 02:34 PM
|
Replies: 9
Views: 2,160
DUMBFOUNDED... still need help!
I see NO way to get the door side window out of my 28 coupe just happens to be the passenger). I have removed the upper trim and sweep, regulator and all window felt channel. Nothing left but door...
|
Forum: Model A (1928-31)
07-21-2013, 02:19 PM
|
Replies: 46
Views: 12,365
|
Forum: Model A (1928-31)
07-20-2013, 08:57 PM
|
Replies: 5
Views: 1,603
Re: Removing side windows in my '28 Coupe
I have everything removed... but, there's no room for the side window to come out, top or bottom. Its too long and wide to come out of either hole. Am I missing something here? Please help.
|
Forum: Model A (1928-31)
07-20-2013, 07:07 PM
|
Replies: 5
Views: 1,603
Removing side windows in my '28 Coupe
:confused: How are the side windows removed from the stated car? I have the regulator out and also the window channel seals. It doesn't want to come out of the top or bottom. Do I need to remove...
|
Forum: Model A (1928-31)
07-20-2013, 04:14 PM
|
Replies: 7
Views: 2,014
Re: Door bumpers with copper clip
I just installed the second door bumper. I did reshape the profile of the copper clip. The back is too high and boxey. I did this easily by using the end end of a bolt about the right size and...
|