Forum: Model-A
12-20-2012, 06:44 PM
|
Replies: 2
Views: 1,205
Re: Aristocrat Gauge Panel
Hi, Carl -
I am still looking forward to seeing the pictures of both panels.
The addition of the engine turned cladding to the repro sounds like it could be very classy.
Please send prices, too....
|
Forum: Model-A
12-14-2012, 07:48 PM
|
Replies: 2
Views: 1,205
Aristocrat Gauge Panel
Looking for an Aristocrat accessory gauge panel for the round-speedometer Model A.
Best contact is email jea777(at)centurylink.net
Substitute @ for (at).
The things we have to do to foil the...
|
Forum: Model-A
08-22-2012, 06:22 PM
|
Replies: 0
Views: 1,095
Rebuilt rear spring - 9 leaf, w/ new covers.
Great for a rat rod or "driver" stock model A Ford.
Rebuilt from original springs, so leaves are correct contour.
Lubricated with cup grease & Teflon tape between all leaves.
Any worn areas where...
|
Forum: Model-A
08-22-2012, 06:19 PM
|
Replies: 1
Views: 1,049
|
Forum: Model-A
08-17-2012, 07:22 PM
|
Replies: 0
Views: 1,004
FS - 9-leaf Rebuilt Rear Spring w/ Covers
Rear spring - 9 leaf
Great for a rat rod or "driver" stock model A Ford.
Rebuilt from original springs, so leaves are correct contour.
Lubricated with cup grease & Teflon tape between all leaves....
|
Forum: Early V8
01-03-2012, 01:50 PM
|
Replies: 0
Views: 1,043
|
Forum: Model-A
01-03-2012, 01:48 PM
|
Replies: 1
Views: 1,535
|
Forum: Model-A
12-19-2011, 06:30 PM
|
Replies: 1
Views: 1,194
Re: Model A locking door handle
Do you still have the handle?
If so, what do you mean by "funky"?
I would also like to see a picture from the keyhole end of the lock cylinder to see if it matches one I have.
I will send my home...
|
Forum: Model-A
12-01-2011, 07:00 PM
|
Replies: 0
Views: 878
Locking Scroll Driver's-side Handle
I would like to find a driver's-side locking scroll door handle for the Model A Ford.
The stem is longer than most and tapped for attaching the inside handle.
The bezel is flat where it meets the...
|
Forum: Model-A
11-10-2011, 08:32 PM
|
Replies: 0
Views: 1,104
Model A Transmission Parts
3-piece U-joint housing.
Upper & lower housing mating faces ground flat for better sealing & bolting.
Sealing felts installed. Ready to run.
New pair cluster & idler shafts.
Throw-out...
|
Forum: Model-A
10-05-2011, 06:51 PM
|
Replies: 0
Views: 1,023
Cling's E-brake Kit
Looking for Cling's E-brake kit P/N 2004.
It is for early Ford juice brakes on a Model A.
Consists of special brackets, cables & connectors
to hook cables to original cross shaft.
|
Forum: Model-A
08-25-2011, 05:51 PM
|
Replies: 0
Views: 938
Locking Scroll Handle Wanted
I am looking for a locking scroll driver's side handle.
See the photo of the passenger side handle I have.
The stem is 3 5/8" long from the bottom of the flat eschuteon. The end of the stem has a...
|
Forum: Model-A
08-22-2011, 07:54 PM
|
Replies: 0
Views: 811
Door & Window Handles
I am looking for a locking scroll handle for the driver's side.
Also looking for window crank handles with counterbore for a screw attaching it to the end of the mechanism stem.
|
Forum: Model-A
05-30-2011, 02:05 PM
|
Replies: 0
Views: 703
Front & Rear Springs w/ Covers
Front spring - 10 leaf
Rebuilt from original springs, so leaves are correct contour.
Lubricated with cup grease & Teflon tape between all leaves.
Any worn areas where leaves contact were blended...
|
Forum: Model A (1928-31)
05-20-2011, 01:37 PM
|
Replies: 2
Views: 1,386
|
Forum: Model A (1928-31)
05-20-2011, 12:04 PM
|
Replies: 2
Views: 1,386
255A Window Crank Handle
Can someone tell me if the 255A window handle was common to any other vehicles?
Ideally, I would like to find original handles (2).
A picture would help a lot for swap meet hunting.
Thanks much-...
|
Forum: Model-A
05-16-2011, 07:57 PM
|
Replies: 5
Views: 1,113
Re: Locking Scroll Handle
Hi, Dave -
I had a bit of good fortune. The owner of the passenger-side handle pictured in that article contacted me with an offer to sell it to me. Of course I bought it.
I still need the driver's...
|
Forum: Model-A
04-26-2011, 04:23 PM
|
Replies: 7
Views: 1,642
|
Forum: Model-A
04-22-2011, 03:19 PM
|
Replies: 5
Views: 1,113
Re: Locking Scroll Handle
Thanks for the info, but check this out -
http://www.fordgarage.com/pages/255Aspecialdeliveryhandle.htm
|
Forum: Model-A
04-20-2011, 12:08 PM
|
Replies: 5
Views: 1,113
Locking Scroll Handle
I would like to find a L/R pair of locking scroll door handles.
The stem is longer than most and tapped for attaching the inside handle.
The bezel is flat where it meets the body.
Parts or leads...
|
Forum: Early V8 (1932-53)
04-10-2011, 08:01 PM
|
Replies: 1
Views: 851
1930s Woody Glass Window Hardware
Does anyone know of parts or info on the window riser mechanism and metal cover plate used on the 1930s woodies?
I know that the Model A and maybe Model B woodies used curtains, and the 1937 had...
|
Forum: Model A (1928-31)
04-10-2011, 07:55 PM
|
Replies: 0
Views: 1,309
255A Special Delivery Window Hardware
Does anyone know of parts or info on the window riser mechanism and metal cover plate used on the 255A ?
Do they interchange with any other bodies?
I would like to purchase a pair of assemblies.
|
Forum: Model-A
01-02-2011, 08:42 PM
|
Replies: 0
Views: 1,259
Front & Rear Springs & Covers - Rebuilt
Front spring - 10 leaf
Rebuilt from original springs, so leaves are correct contour.
Lubricated with cup grease & Teflon tape between all leaves.
Any worn areas where leaves contact were blended...
|
Forum: Early V8
01-02-2011, 08:37 PM
|
Replies: 0
Views: 1,532
1932-1940 Tranny Parts
81A-7105 Synchro hub w/good 81A-7069-B thrust washer
48-7518 Inspection cover (Blasted & painted black)
??-7231 First/Reverse shifter fork (Fits 81A7222 housing)
81A-7240 Shifter shaft – 1st/Rev....
|
Forum: Model-A
01-02-2011, 08:18 PM
|
Replies: 0
Views: 1,307
|