Forum: Late V8 (1954+)
06-27-2023, 11:20 PM
|
Replies: 4
Views: 987
Re: 1957 Thunderbird Horn wire
The horn wire connects to the main harness at a yellow pigtail located close to where the two green wires exit the harness going to the stoplight switch. (between battery and brake booster)
|
Forum: Late V8 (1954+)
02-11-2023, 08:55 PM
|
Replies: 26
Views: 3,047
Re: Fordomatic Ring Gear Balancing
Before you have it fitted you might check that there is a little step machined on the inside of the ring. When searching the vendors for this part quite a while ago I noticed that CASCO's catalog...
|
Forum: Late V8 (1954+)
02-10-2023, 08:54 PM
|
Replies: 5
Views: 999
Re: 56 door panels
Make one panel out of clear Plexiglass. Easy to see location of all holes.
|
Forum: Late V8 (1954+)
07-24-2022, 10:02 PM
|
Replies: 31
Views: 2,839
Re: My turn signal switch is shot
Take another look. Your switch is rectangular with two straight slick sides. The passenger example shown has one curved side, with sculpted indents to locate and hold the left and right positions. On...
|
Forum: Late V8 (1954+)
02-22-2022, 08:40 PM
|
Replies: 14
Views: 1,076
Re: Mercury 312 flex plate
CASCO Thunderbird parts lists a correctly re machined ring gear for $75. Other Thunderbird vendors show them for about half that price, but I suspect they are part of a run made several years ago...
|
Forum: Late V8 (1954+)
09-18-2021, 07:29 PM
|
Replies: 17
Views: 2,844
|
Forum: Late V8 (1954+)
09-13-2021, 01:01 PM
|
Replies: 17
Views: 2,844
|
Forum: Late V8 (1954+)
09-12-2021, 09:27 PM
|
Replies: 17
Views: 2,844
|
Forum: Late V8 (1954+)
07-14-2021, 08:12 PM
|
Replies: 31
Views: 2,405
Re: best way to get heads off
The extra steam holes drilled in the block between the center cylinders could have been added later, but my bet would be the block is the same vintage as the heads.
|
Forum: Late V8 (1954+)
07-13-2021, 06:05 PM
|
Replies: 31
Views: 2,405
|
Forum: Late V8 (1954+)
07-04-2021, 09:01 PM
|
Replies: 2
Views: 566
Re: 56 t-bird 312 mech temp sender
O'Reilly stores have a section for after market instruments, and on the display wall you will find a pack of adapters (3 or 4) for about $10. Both the large, '55/'56, and the small '57 are included....
|
Forum: Late V8 (1954+)
06-30-2021, 08:06 PM
|
Replies: 19
Views: 4,281
Re: Valve adjustment on 312
Since you say that the 5 and 7 exhaust valves were very tight and that there was very little tension on the springs, then I would say you have severely recessed valve seats. If this is what has...
|
Forum: Late V8 (1954+)
04-07-2021, 07:27 PM
|
Replies: 10
Views: 1,117
|
Forum: Late V8 (1954+)
03-23-2021, 08:24 AM
|
Replies: 11
Views: 1,071
Re: Trans Dipstick
There is NO o-ring on a Fordomatic dipstick tube. The tube to pan seal is by flare connection.
|
Forum: Late V8 (1954+)
10-25-2020, 11:04 PM
|
Replies: 92
Views: 13,334
Re: Fordomatic late shifting ('57 thunderbird)
Don't try to bend the bracket, it looks fine as is. The piston does seem to be pushed out to far, the narrow part of the piston should not be visible outside of the main body. (compare to left valve...
|
Forum: Late V8 (1954+)
10-20-2020, 09:50 PM
|
Replies: 92
Views: 13,334
Re: Fordomatic late shifting ('57 thunderbird)
Well that's unfortunate, sure felt the spring would be the culprit. I still feel that the transmission is seeing more throttle pressure than is really there. First I would double check that the...
|
Forum: Late V8 (1954+)
10-20-2020, 08:50 AM
|
Replies: 92
Views: 13,334
Re: Fordomatic late shifting ('57 thunderbird)
A little tip that you may find useful when it comes time to reinstall. If you replace the stock slot head screws with equivalent size socket cap head screws, a flat head allen wrench (not ball end)...
|
Forum: Late V8 (1954+)
10-20-2020, 08:26 AM
|
Replies: 3
Views: 1,177
|
Forum: Late V8 (1954+)
10-17-2020, 10:32 AM
|
Replies: 92
Views: 13,334
|
Forum: Late V8 (1954+)
10-17-2020, 09:43 AM
|
Replies: 92
Views: 13,334
Re: Fordomatic late shifting ('57 thunderbird)
Just looked at your video. The spring is something added by a rebuilder to either compensate for worn governor or as a performance modification to do exactly what you are describing, late shifting....
|
Forum: Late V8 (1954+)
08-20-2020, 11:00 AM
|
Replies: 5
Views: 839
Re: 56 t/bird auto
Fatsco transmission is another supplier that has all rebuild wear parts, gaskets, seals clutches, steel plates etc. But be aware the Thunderbird transmission is a hybrid. Main case is medium case but...
|
Forum: Late V8 (1954+)
07-28-2020, 01:07 PM
|
Replies: 9
Views: 2,908
|
Forum: Late V8 (1954+)
07-13-2020, 01:07 PM
|
Replies: 3
Views: 1,177
Re: 57 Tbird bonnet, (hood) release
Go to passenger side and reach up between exhaust and heater box with a pair of vice grips. Clamp onto the bar that connects the two latches, and with handle pointing forward, pull down.
|
Forum: Late V8 (1954+)
09-09-2019, 07:47 PM
|
Replies: 3
Views: 1,176
|
Forum: Late V8 (1954+)
03-02-2019, 09:28 PM
|
Replies: 1
Views: 1,024
|