Forum: Early V8 (1932-53)
07-09-2021, 12:37 PM
|
Replies: 5
Views: 956
Re: Heater
South wind gas heaters are almost immediate heat and safe if installed properly. I have had a number of them in autos and even in two aircraft (which were approved for use by the FAA) They are...
|
Forum: Early V8
06-22-2021, 01:21 PM
|
Replies: 0
Views: 571
|
Forum: Early V8 (1932-53)
04-27-2021, 09:18 PM
|
Replies: 9
Views: 1,567
|
Forum: Early V8 (1932-53)
07-23-2020, 02:43 PM
|
Replies: 3
Views: 831
|
Forum: Early V8 (1932-53)
06-18-2020, 03:43 PM
|
Replies: 38
Views: 4,780
Re: Spring Carlisle
The country is going to have to start opening up sometime, someway, soon. Maybe this is how it will happen.
|
Forum: Early V8 (1932-53)
06-05-2020, 04:55 PM
|
Replies: 106
Views: 15,925
|
Forum: Early V8 (1932-53)
03-22-2020, 04:13 PM
|
Replies: 33
Views: 3,918
Re: Low oil pressure solved
Another oil low oil pressure hint is if a bypass oil filter has been installed without a 60 thousands reducer in the inlet oil line to the oil pressure will read very low.
|
Forum: Late V8
10-10-2019, 11:19 AM
|
Replies: 0
Views: 958
|
Forum: Early V8
10-10-2019, 11:12 AM
|
Replies: 0
Views: 845
|
Forum: Early V8 (1932-53)
10-03-2019, 07:12 PM
|
Replies: 24
Views: 4,061
Re: WWII gas ration sticker placement?
About the ration stickers, as I remember the A got 5 gal, B got 20 gal per week and C sticker was allowed all they needed for their necessary war related business. It was to conserve rubber tires...
|
Forum: Early V8 (1932-53)
10-03-2019, 06:49 PM
|
Replies: 24
Views: 4,061
Re: WWII gas ration sticker placement?
It was to be placed on the bottom right corner of the passenger side windshield. I still have a beat up one on my 35 ford windshield. I remember sometimes being allowed to set in the front seat,...
|
Forum: Early V8 (1932-53)
09-12-2019, 01:36 PM
|
Replies: 6
Views: 1,250
Re: Sudden Drop in Gas Mileage
Any obstruction of the air filter such as dirt, or the wrong filter will affect mileage. Even a worn choke butterfly bearing surface can cause air flow obstruction. Also make sure the choke...
|
Forum: Early V8 (1932-53)
08-30-2019, 10:45 AM
|
Replies: 35
Views: 5,279
|
Forum: Early V8 (1932-53)
08-30-2019, 10:32 AM
|
Replies: 35
Views: 5,279
Re: Is this an ok radiator?
As long as the ph stays 7.0, neurtal it can't react with anything. As soon as you add additives, unless they are neutral, things change. Nitrozene tape is the easiest and cheapest way to test...
|
Forum: Early V8 (1932-53)
08-03-2019, 12:49 PM
|
Replies: 19
Views: 5,189
|
Forum: Early V8 (1932-53)
08-03-2019, 12:34 PM
|
Replies: 20
Views: 5,247
Re: Real story on Lebarron Bonney?
I find that when this old 87 year old takes his 84 year old ford to a car show hardly any of this generation of show goers stop to hardly look or talk. The entrance fees have gone up above...
|
Forum: Early V8 (1932-53)
04-03-2019, 12:50 PM
|
Replies: 43
Views: 6,729
|
Forum: Early V8 (1932-53)
01-19-2019, 05:01 PM
|
Replies: 27
Views: 5,319
Re: 1935 Ford 15-P
I don't see how they ever got the Center of Gravity (CG) anywhere near correct with the heavy engine behind what looks to be the wing spar position. I'll bet it was a doozy to fly if it did ever fly...
|
Forum: Early V8 (1932-53)
12-24-2018, 03:05 PM
|
Replies: 15
Views: 3,052
Re: 35 Ford Cooling Issues
Any engine with babbot bearings should not be cooled with ethylene base antifreeze. If the ethylene type happens to get in crankcase (Oil) it will ruine the bearings. Propylene will not and is pet...
|
Forum: Early V8 (1932-53)
12-17-2018, 11:35 AM
|
Replies: 30
Views: 7,853
Re: What’s so great about the Flathead Ford V8?
What friends the Ford flatheads have been to me, I've had them since the 2nd WW as a kid starting to drive, through the Korean war, being there when I returned, then the wonderful feeling I get...
|
Forum: Early V8 (1932-53)
12-07-2018, 02:50 PM
|
Replies: 5
Views: 1,357
Re: engine identification
I was hoping the block could be furthur identified by the photo of the block stampings I posted but expect that recast blocks had many different than original Ford stamps. It should have domed...
|
Forum: Early V8 (1932-53)
12-07-2018, 12:17 PM
|
Replies: 5
Views: 1,357
engine identification
I bought this 21 bolt, water pump in block(covered) Heads are numbered as for domed pistons Block has the pictured markings. There is a sticker on the head from a ford approved rebuilder. What year...
|
Forum: Early V8 (1932-53)
12-05-2018, 01:14 PM
|
Replies: 72
Views: 11,566
|
Forum: Early V8 (1932-53)
12-02-2018, 12:07 PM
|
Replies: 72
Views: 11,566
Re: It's tough
Thanks for your concern folks, I really appreciate it. Keith Oh
|
Forum: Early V8 (1932-53)
11-30-2018, 10:05 AM
|
Replies: 72
Views: 11,566
It's tough
I lost my wife of 65 years this week, sure is tough. Thought some of my Ford Barn friends may care. Keith Oh
|