Forum: Early V8 (1932-53)
09-26-2019, 11:00 PM
|
Replies: 10
Views: 1,886
|
Forum: Early V8 (1932-53)
09-25-2019, 07:52 PM
|
Replies: 10
Views: 1,886
Are all yellow top coils 12 volt
Hello again,
I was on a job and a guy was going to junk a eac Mercury. I asked if I could save it and he said yes. I am now trying to determine if the coil and voltage regulator are 6 or 12 volts. ...
|
Forum: Early V8 (1932-53)
08-28-2018, 09:43 AM
|
Replies: 5
Views: 1,211
|
Forum: Early V8 (1932-53)
08-28-2018, 12:21 AM
|
Replies: 5
Views: 1,211
Bell systems truck
Well hello again Ford barn. It has been a long time since I've posted anything, so long that I don't remember if I had ever done so. I have been working on this truck for most of my son's life. He...
|
Forum: Early V8 (1932-53)
07-21-2014, 11:20 PM
|
Replies: 6
Views: 1,362
Re: 39-41backing plates still usable
Mr Texas I thank you that is the answer. After working on them again , the small clip in the first pic was just flattened. Once bent back the drivers side plate is good. Going to fabricate the...
|
Forum: Early V8 (1932-53)
07-17-2014, 04:30 PM
|
Replies: 6
Views: 1,362
|
Forum: Early V8 (1932-53)
07-17-2014, 12:28 PM
|
Replies: 6
Views: 1,362
39-41backing plates still usable
So hello fellas, in the process of getting my 39 pick up on the road I noticed that the hold down clips are all broken except one. Can these be replaced? I ask because they look like they ar e...
|
Forum: Early V8
12-18-2013, 09:48 PM
|
Replies: 1
Views: 789
1935-40 frame section
Looking for a piece of frame to repair mine. Usual spot where x member meets outer rail . Drivers side.. Only about a foot long right where it kicks up. Thank you ford barn
|
Forum: Early V8
12-22-2011, 11:37 PM
|
Replies: 0
Views: 1,145
1935-36 column drop parts
I need a couple column drop parts. Pretty much all of them. Cyl. no key is okay. ring with switch nail and on/off lever. On/off plate. cap for the end. bearing and spring for detent. and the...
|
Forum: Early V8 (1932-53)
04-07-2011, 09:11 PM
|
Replies: 8
Views: 7,527
Re: Flathead Starter Brush Assembly???
I just took mine apart. If you push the brushes all the way up against the springs until they are pushing against the side of the brush they will stay there. Then once everything is assembled you...
|
Forum: Early V8
03-03-2011, 10:31 PM
|
Replies: 4
Views: 1,878
1950-51 merc pass side water pump
Need a pass. side flathead merc water pump with to mounting tabs. not the 45* mounts. buildable core. have wide belt merc pump i'm willing to trade
|