Forum: Model A (1928-31)
03-29-2024, 04:09 PM
|
Replies: 36
Views: 3,251
Re: Peep mirrors
I have the same mirrors and had the same issue. I reversed the c-clamp and it changed the angle of the mirror stock
|
Forum: Model A (1928-31)
12-31-2023, 06:02 PM
|
Replies: 12
Views: 1,176
Re: Damaged Babbitt
The main journals are .001 out of round. Rear journal is 1.618 and 1.619. Spec is 1.624
|
Forum: Model A (1928-31)
12-31-2023, 04:11 PM
|
Replies: 12
Views: 1,176
Re: Damaged Babbitt
There were shims in the front cap all others there was none. All of the journals look nice but measure under size.
|
Forum: Model A (1928-31)
12-31-2023, 01:21 PM
|
Replies: 12
Views: 1,176
Damaged Babbitt
I disassembled the engine on my A and found this broken bearing, front of the rear main cap. Other than this the rest of the bearings look good. I assume there is no repair to this?
|
Forum: Model A (1928-31)
11-02-2023, 09:55 AM
|
Replies: 8
Views: 1,039
Re: Spreading frame to install engine
I have a spreader. I’m curious if the amount of side force effects felt vibration on the engine.
And how much spread needed to install is normal. Are all frames about the same?
I am installing new...
|
Forum: Model A (1928-31)
11-01-2023, 04:43 PM
|
Replies: 8
Views: 1,039
Spreading frame to install engine
My frame needs to be spread 1/4 inch to install the engine on my A. Is this tension part of how the side rubber mounts work? Is there such a thing as too much tension?
|
Forum: Model A (1928-31)
08-31-2023, 12:09 PM
|
Replies: 62
Views: 6,455
|
Forum: Model A (1928-31)
08-24-2023, 08:34 AM
|
Replies: 83
Views: 9,234
Re: 5 Speed Conversion
Are the rear radius rods bolted solid to that new transmission bracket? If so how can the rear end articulate?
|
Forum: Model A (1928-31)
08-19-2023, 08:41 AM
|
Replies: 14
Views: 2,968
|
Forum: Model A (1928-31)
06-28-2023, 04:07 PM
|
Replies: 14
Views: 2,968
Re: Model A rear tire size verses cruise RPM
I am running stock wheels. I was using a different calculator. A gear change to 3.54 would yield around a 147 rpm drop. So if the next size up tire 6.00x 19 comp H is truly a 31 inch tall tire from...
|
Forum: Model A (1928-31)
06-28-2023, 09:00 AM
|
Replies: 14
Views: 2,968
Model A rear tire size verses cruise RPM
I have a stock 31 A Tudor with 5.00x19 tires on it now. I would like to lower the overall RPM at cruising speed by changing the rear tires to either a 6.00 or 6.50.
In stock form is there enough...
|
Forum: Model A (1928-31)
03-09-2023, 11:48 AM
|
Replies: 59
Views: 38,816
|
Forum: Model A (1928-31)
03-09-2023, 09:30 AM
|
Replies: 59
Views: 38,816
Re: Marvel Carburetor Disection
I have one of these carbs on my 31 A that will not idle or rev up without the choke partially on. The mount flange was severely warped, which I fixed. Is there other areas that have a warp issue?...
|