Forum: Model T (1909-1927)
12-03-2017, 03:51 PM
|
Replies: 1
Views: 1,355
|
Forum: Model T (1909-1927)
09-24-2016, 05:34 PM
|
Replies: 13
Views: 2,681
Re: Dads old "T".
Just curious, where abouts in Iowa. my dad lives in
sioux city, he has a 1926 model t roadster pickup
|
Forum: Model T (1909-1927)
03-17-2016, 01:13 PM
|
Replies: 10
Views: 1,702
Re: ruxtell rear end
Sunny Brook Farm, I did figure out to post the above 2 pictures, hope you enjoy, the green car is my 51 Crosley CD wagon, dads is 20 horsepower mine is 26 horsepower so we travel togeather and don't...
|
Forum: Model T (1909-1927)
03-17-2016, 01:10 PM
|
Replies: 10
Views: 1,702
|
Forum: Model T (1909-1927)
03-17-2016, 01:07 PM
|
Replies: 10
Views: 1,702
|
Forum: Model T (1909-1927)
03-16-2016, 08:46 PM
|
Replies: 10
Views: 1,702
Re: ruxtell rear end
Sunnybrook farm, if I new how to add a picture I would, dad had the T out in the snow this winter, just last week he drove up to the nursing home to visit mom, they have been married 64 yrs. ended...
|
Forum: Model T (1909-1927)
03-16-2016, 03:20 PM
|
Replies: 10
Views: 1,702
Re: ruxtell rear end
Sunnybrook farms, thank you, this is just what I needed,
thanks again,
Neal in Iowa
|
Forum: Model T (1909-1927)
03-16-2016, 02:28 PM
|
Replies: 10
Views: 1,702
ruxtell rear end
Trying to help my 82 yr. old dad remember how to shift the ruxtell rear end, looking for advice on when to shift or unshift, rpm wise, speed wise. under power or off the throttle, etc. 1926 Roadster...
|
Forum: Model T (1909-1927)
07-06-2015, 03:38 PM
|
Replies: 4
Views: 1,556
|
Forum: Model T (1909-1927)
07-05-2015, 08:55 AM
|
Replies: 4
Views: 1,556
|
Forum: Model T (1909-1927)
07-04-2015, 03:56 PM
|
Replies: 4
Views: 1,556
Nice car cover
Looking for suggestions on a nice car cover for my dad's 1926 model t roadster pickup, just curious if anyone has purchased one or know where the place is to get one.
Thanks in advance for any...
|
Forum: Model T (1909-1927)
10-09-2014, 08:30 PM
|
Replies: 3
Views: 1,527
Re: crank start handle bushing
Thanks to all that replied, this is my dad's model t and for a 82 year old he drives it almost daily to coffee , car shows etc., just trying to keep up with general maintenance for him,
Thanks...
|
Forum: Model T (1909-1927)
10-08-2014, 08:48 PM
|
Replies: 3
Views: 1,527
crank start handle bushing
Hello. trying to find out what it takes to install a new crank start handle bushing for my dad on his 1926 model T roadster pickup, best way to remove the old one then. procedure to install the new...
|
Forum: Model T (1909-1927)
09-26-2014, 05:57 PM
|
Replies: 3
Views: 2,387
Re: 1926 model t roadster pickup question
Farmallcub49, Thanks for the answer, this truck has a license plate bracket below the crank handle and a straight bar between the lights, would that possibly make it a late 1926?
Neal
|
Forum: Model T (1909-1927)
09-26-2014, 02:57 PM
|
Replies: 3
Views: 2,387
1926 model t roadster pickup question
Hello, I would like to know if a 1926 model T roadster pickup came with a bar between the headlights, my dad's has one but at a car show last night someone said it would not be original, we think...
|
Forum: Model T (1909-1927)
09-25-2014, 03:23 PM
|
Replies: 4
Views: 2,514
|
Forum: Model T (1909-1927)
09-25-2014, 01:08 PM
|
Replies: 4
Views: 2,514
Ruxtell rearend question
Hello, Could someone tell me the proper ways in which to shift a 2 speed rear end, it is a 1926 model T truck, I was under the impression that you shifted it into gear while moving, but unclear...
|
Forum: Model T (1909-1927)
06-13-2014, 10:48 AM
|
Replies: 6
Views: 1,986
water pump grease ?
Hello, could someone tell me on a 1926 model T pickup what should we use in the grease cups for grease on the water pump.
Thanks
Neal in Iowa
|
Forum: Model T (1909-1927)
04-12-2014, 01:39 PM
|
Replies: 7
Views: 2,397
Re: hardly any break pedal
Steve J. thanks for the help, I don't mind the hard work or the cussing as long as I know what I should be doing, my dad is 82 years old and will help but I try to keep him from a lot of tough labor...
|
Forum: Model T (1909-1927)
04-12-2014, 12:04 PM
|
Replies: 7
Views: 2,397
Re: hardly any break pedal
J Franklin, thanks, will I be looking for missing lining or chunked out pieces, also if the lining is gone is it a big job to replace the lining, and is it something I will do in place.
Neal In...
|
Forum: Model T (1909-1927)
04-12-2014, 11:41 AM
|
Replies: 7
Views: 2,397
hardly any break pedal
Hello, I took my dad's 1926 model t roadster pickup out for a spin, I noticed that the brake pedal goes all the way to the floor, being a novice is this something that just needs adjustment, I do...
|
Forum: Model T (1909-1927)
11-15-2013, 07:03 PM
|
Replies: 3
Views: 1,342
what oil should I use
Could anyone give me a recommendation on what engine oil (brand and weight) to use on my dad's 1926 model T truck, also on average how many quarts does it take, I wasn't sure if it had to be...
|
Forum: Model T (1909-1927)
11-10-2013, 02:59 PM
|
Replies: 4
Views: 1,780
Re: Holley NH carb w/swivel style adjusting needle
guys, the u-joint is all new from Lang's it looks as if when you rotate it is taking the paint off the edges, I think it may just be crimped to tight, I thought about just wire brushing the painted...
|
Forum: Model T (1909-1927)
11-10-2013, 09:22 AM
|
Replies: 4
Views: 1,780
Holley NH carb w/swivel style adjusting needle
Hello, I just recently got dad's 26 T pickup going after installing a new NH carb. etc. you guy's helped get me close on the swivel setting for starting ,now I have 2 more questions. When running the...
|
Forum: Model T (1909-1927)
11-08-2013, 03:35 PM
|
Replies: 5
Views: 1,349
Re: Carb adjustment
Guy's thanks for the quick reply, well I set it at about 1 full turn and it fired right up and just purred, I will fine tune it later but one issue that came up is that the knuckle fitting does not...
|