Forum: Early V8 (1932-53)
07-31-2022, 03:58 PM
|
Replies: 3
Views: 718
Re: Tooth count
32/9 = 3.55:1
11/39= 3.54:1
The diff in the avatar is marked 11 39 and checked put to 3.54:1.
|
Forum: Early V8 (1932-53)
07-31-2022, 03:52 PM
|
Replies: 6
Views: 900
Re: front motor mount cushions
The Bob Drakes mounts are the best. The Speedway mounts do not have the cupped base washer. There is nothing to prevent the cushion from expanding and flattening under load.
|
Forum: Early V8 (1932-53)
12-26-2021, 09:51 AM
|
Replies: 11
Views: 2,408
|
Forum: Early V8 (1932-53)
12-18-2021, 11:59 AM
|
Replies: 27
Views: 2,858
Re: another great barner gone
Rest in peace Bill. You will be missed. I first met Bill at the Barners bash in 2010.
Jeff, this is the tool Bill made for the OP sensor.
|
Forum: Early V8 (1932-53)
10-22-2021, 02:05 PM
|
Replies: 13
Views: 1,552
|
Forum: Early V8 (1932-53)
10-21-2021, 11:21 AM
|
Replies: 9
Views: 1,013
|
Forum: Early V8 (1932-53)
10-21-2021, 11:13 AM
|
Replies: 9
Views: 1,013
Re: 40 Ford 1/2 ton pick up trans removal.
I did a clutch replacement last year on the avatar pickup. The trans can be removed from the floor access. The rear end and drive shaft has to be move back about 6" so you have enough room to pull...
|
Forum: Early V8 (1932-53)
10-01-2021, 01:43 PM
|
Replies: 12
Views: 1,513
|
Forum: Early V8 (1932-53)
09-27-2021, 06:26 PM
|
Replies: 13
Views: 1,552
Re: Oil Pressure Sender
A Standard Motor Products PS60 has been on my 59AB in the pickup for 12 years. Verified it with a mechanical gauge.
|
Forum: Early V8 (1932-53)
09-24-2021, 01:34 PM
|
Replies: 8
Views: 2,002
|
Forum: Early V8 (1932-53)
09-24-2021, 01:16 PM
|
Replies: 8
Views: 2,002
Re: 1939/1940 ford grille
39 deluxe.
40 standard/pickup has a wider center bar. Link to the front pic of my pickup below.
https://www.fordbarn.com/forum/album.php?albumid=2248&pictureid=18361
|
Forum: Early V8 (1932-53)
08-10-2021, 07:54 AM
|
Replies: 18
Views: 1,903
|
Forum: Early V8 (1932-53)
05-08-2021, 08:44 AM
|
Replies: 11
Views: 1,915
|
Forum: Early V8
05-08-2021, 08:27 AM
|
Replies: 19
Views: 6,126
|
Forum: Early V8 (1932-53)
04-25-2021, 08:35 AM
|
Replies: 4
Views: 687
Re: visor
Check this thread: https://www.fordbarn.com/forum/showthread.php?t=203088
The screws are #12 X 1 1/2" on the sides. I believe they are the same on the center bracket. I have not removed that to...
|
Forum: Early V8
03-13-2021, 08:59 AM
|
Replies: 19
Views: 6,126
|
Forum: Early V8 (1932-53)
10-05-2020, 01:24 PM
|
Replies: 10
Views: 1,478
Re: 1941 Pickup Interior Install Help
This kit came from Dennis Carpenter. The only place the needed trimming was over the windshield header. The headliner panel slides between the roof and the header. I had to trim about 3/8" off the...
|
Forum: Early V8
09-29-2020, 10:55 PM
|
Replies: 19
Views: 6,126
|
Forum: Early V8 (1932-53)
09-25-2020, 03:22 PM
|
Replies: 23
Views: 2,645
Re: New Rebuild Overheating
How did you set the timing? A stock 59 engine has no timing marks. I have a 59 in my pickup. I had to use a vacuum gauge to set the timing because I have a Mallory electronic distributer. I had...
|
Forum: Early V8
09-07-2020, 10:44 AM
|
Replies: 19
Views: 6,126
|
Forum: Early V8
08-02-2020, 03:31 PM
|
Replies: 19
Views: 6,126
|
Forum: Early V8 (1932-53)
07-17-2020, 10:18 AM
|
Replies: 36
Views: 3,750
|
Forum: Early V8 (1932-53)
07-15-2020, 02:32 PM
|
Replies: 3
Views: 1,195
Re: Possible fishing scam
He posted that he is looking for front end alignment tools.
https://www.fordbarn.com/forum/showthread.php?t=284082
|
Forum: Early V8 (1932-53)
06-10-2020, 09:43 PM
|
Replies: 2
Views: 1,020
|
Forum: Early V8 (1932-53)
06-10-2020, 04:45 PM
|
Replies: 2
Views: 1,020
Door stay diagram for 53 Courier
Does any one have a diagram for the door stay on the rear door of a Courier?
I believe the one on mine is missing some parts.
Thanks in advance.
|