The condenser man
 

I just shipped two Loadamatic distributors for use with teapot Holley 4 barrels.
My customer sent me a couple vintage NOS P&G dual point conversion kits
for the builds.

On these setups the condenser goes on the outside. I used "tubmans"

(Dennis Odoms) repop Mallory big brass condensers which not only function
perfectly but against the polished aluminum dist housings looked sooooooo
good. My customer was thrilled.
A great product Dennis.
Charlie ny

Re: The condenser man
 

Charlie,

Thanks for the kind words. I'm glad you could find a good home for those. In my opinion, nothing looks worse than a plain ole condenser hangin' off the side of a vintage hi-performance distributor.

Denny

Re: The condenser man
 

I need to get a few of these before these disappear as well. Thanks for taking this project on!

Re: The condenser man
 

Tim,
You will not be disappointed....remember these are fresh & new and with
tubman on the job we will never run out.
Charlie ny

Re: The condenser man
 

If endorsed by Charlie NY, then that's good enough for me.