Need a really good crankshaft grinder
 

I am looking for someone on the east coast that can grind a model a ford crankshaft to factory spec's.i have tried who clame too be the best their is and they all fall short according to the factory spec's when it comes to the t.i.r.can someone please help me.:(

Re: Need a really good crankshaft grinder
 

Places for J and M Machine co. near
http://www.google.com/maps/vt/data=A...HVKGtAG8gAqMGw
J&M Machine Company: Engine Rebuilder


J and M Machine are in southbourogh, Ma. Phone 508-460-0733

Re: Need a really good crankshaft grinder
 

I haven't tried this soarce but it was given to me by a guy at a swap meet in South Carolina.
Crankshaft rebuilding service standardcrankshaft.com or phone 704-392-4371 Charlotte North Carolina It was said that they can rebuild any crankshaft. Good luck.

Re: Need a really good crankshaft grinder
 

Ck out this place also

http://www.schwalms.com/

Re: Need a really good crankshaft grinder
 

X's 2

Re: Need a really good crankshaft grinder
 

Make sure you have the correct radius ground on the brgs or you may be looking at a broken crankshaft one day.

Re: Need a really good crankshaft grinder
 

If you are talking factory specs don't you need someone who can build up the journals with metal deposition and then turn them down to factory specs? Otherwise when grinding you would by definition be making them smaller in diameter.

Re: Need a really good crankshaft grinder
 

Here are some notes on crank shafts:

Crank grinding