The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Early V8 (1932-53) (https://www.fordbarn.com/forum/forumdisplay.php?f=4)
-   -   Hesitation (https://www.fordbarn.com/forum/showthread.php?t=11393)

01aford 08-21-2010 08:12 PM

Hesitation
 

Took the 40 (85 hp stock flathead) out for the longest drive and highest speed yet. Drove great at first. I drove it for 30 miles. Of those 30 miles 10 miles were at 55 mph. I noticed that the car started hesitating towards the end of the drive. I have a new Skip coil and a new good condenser. (so I know that’s good) What do you guys think? Picked up some trash in the carb? I let it cool down and it’s still running poor.

gmc1941 08-21-2010 08:16 PM

Re: Hesitation
 

Are your fuel lines clear? Any crap in the tank? If so it's in your lines and in your fuel pump. Try blowing your fuel back to the tank. If it runs better, you now know your problem.

01aford 08-21-2010 08:35 PM

Re: Hesitation
 

Good point about the gas line. It's been checked and all is clear. (Air moves freely to the tank and gas comes through the line with no issue).

G.M. 08-21-2010 09:15 PM

Re: Hesitation
 

Put a fuel gauge between the pump and carb to see if you have fuel pressure all the time. G.M.

01aford 08-21-2010 09:24 PM

Re: Hesitation
 

I don't have a fuel gauge.

Craig CT 08-21-2010 10:05 PM

Re: Hesitation
 

If you can drive it up a rather steep long hill that should tell you if it's the fuel pump, or just get a new one. Happy motoring, Craig.

01aford 08-21-2010 10:38 PM

Re: Hesitation
 

Hills don't effect it either way. I noticed the hesitation when running 50 on a flat road giving just a little gas. It got worse as I got closer home. When I went up a hill it was still there the same as if I was on flat ground.
Power valve maybe??
I have a new one from Ken sitting on the work bench. I'll try to get it on in the morning.

01aford 08-22-2010 02:05 PM

Re: Hesitation
 

It was the Power Valve. Put one of Ken's in and runs great.

ken ct 08-22-2010 02:49 PM

Re: Hesitation
 

Good to hear that.Slop between the little link from the accel. pump to the throttle shaft will also sometimes cause this. Usually the bottom pin and middle hole will ware causing a hesitation with lite throttle settings.Glad you found the problem.ken ct.


All times are GMT -5. The time now is 03:08 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.