Mag wheels for 1940 Ford Does anyone know where I can buy mag wheels for the wide bolt pattern on 1939-40 Fords?
|
Re: Mag wheels for 1940 Ford Hi Bill; The Wide [10 3/4"] pattern was 36-39 Fords with 1/2" Studs. The early circle trackers used this pattern. NOTE: Later and present circle trackers use this pattern with 5/8" inch studs. The modern wheels are available from racers BUT, they will have 5/8" bolt holes. Hope this helps. Newc
|
Re: Mag wheels for 1940 Ford The 10 3/4" pattern is the standard for dirt track race cars today, thus many different wheels are available today---but they are all aluminum, not magnesium. Halibrand made magnesium wheels many years ago, odds are finding a full set near impossible. The problem with the current aluminum wheel is the availability of wheel widths/offsets you can use. Said another way, the wheels may be "Special Order".
As stated earlier, the current aluminum wheels are made to be used with 5/8" studs, yours are 1/2". Many years ago, special lug nuts were available to use the larger hole wheel on a 1/2" wheel stud. I haven't seen any offered in years-----but they would be fairly easy to have a set made. |
Re: Mag wheels for 1940 Ford Sorry for the gap in my post, my lovely wife doesn't like to eat dinner alone!
In Chattanooga there are many, many old time racers. Some may have the lug nuts you need in the scrap drawer---it's worth asking around. Also, there should be several dealers for the aluminum wheels, you probably need to talk to some about your wheel needs. |
Re: Mag wheels for 1940 Ford I happen to think during one of my many trips to the "Necessary Room" during the night-----contact "OoltewahSpeedShop" on the Fordbarn. He is a neighbor of yours and a stock car racer. He might be of some assistance.
|
Re: Mag wheels for 1940 Ford You didn't make clear which wheel pattern you have; as stated above, 37-39 use the 5 on 10 3/4 pattern while the 40 -48 use 5 on 5 1/2 pattern, which is the same as some Lincolns, most all Ford trucks, and some Dodge trucks, in which case you choices are plentiful, and relatively cheap. Good luck!
|
Re: Mag wheels for 1940 Ford The 1936 to 1939 Ford car wheels have a 5 lug X 10 1/4" bolt pattern.
. |
All times are GMT -5. The time now is 04:38 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.