Early Ford Tie Rod Ends I did a search and came up with nothing so for the early Ford machinists out there - does anybody know the angle of the taper on an early ford ('40 - '48) tie rod end? Is a standard or special reamer available?
|
Re: Early Ford Tie Rod Ends 7 degrees. Standard Ford taper
|
Re: Early Ford Tie Rod Ends I've been using this one from Snap On for years... http://buy1.snapon.com/catalog/item....re&dir=catalog
|
Re: Early Ford Tie Rod Ends Thank you and Merry Christmas.
|
Re: Early Ford Tie Rod Ends Speedway has both taper reamers and rh and lh taps for tie rods,when I bought Mine they were US made. John
|
All times are GMT -5. The time now is 09:57 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.